NEC Univerge SV9100 Hardware Manual page 372

Issue 1.2
5 - 112
14. Remove the connector cover (rubber) from the bottom of the
multiline terminal.
Figure 5-125 Removing the Connector Cover
15. Insert the lower claws of the Bottom Unit (see
Installing the Bottom
terminal.
Figure 5-126 Installing the Bottom Unit
16. Align connector on inside of bottom unit and push down until
unit snaps into place.
Installing DT Series Digital and IP Multiline Terminals
Unit) into precut holes on the multiline
UNIVERGE SV9100
Figure 5-126