NEC Univerge SV9100 Hardware Manual page 119

UNIVERGE SV9100
System Hardware Manual
The 9.5" chassis can be stand mounted using the brackets supplied. The following
section describes this procedure.
Using the chassis stand unit (stand/floor mounting), will increase the
height of the chassis by 50 mm.
1. Position the 9.5" Base Chassis so that the EXIFU slot is on top.
2. Align the Base unit with holes A, B, C and D on the lower side of the
CHS2UG B chassis. Attach with the provided M4 x 14 screws.
Figure 3-59 Attaching the Base Stand
Issue 1.2
3 - 47