NEC Univerge SV9100 Hardware Manual page 444

Issue 1.2
Figure 6-22 NEC Terminal Connection to an IEEE 802.3af PoE Switch
6 - 32
3. Connect the NEC VoIP telephone to the TEL connector on the
ILPA-R adapter with the LAN cable provided with the adapter.
If a customer-provided cable is used, the total length from

the switch to the telephone should be less than 328 feet.
The adapter can be positioned either closer to the keyset

or switch – it does not matter.
4. Connect a cross-over LAN cable to the LAN connector on the
ILPA-R adapter. Plug the opposite end into the switch which is
to provide power to the telephone. Refer to
Terminal Connection to an IEEE 802.3af PoE
If a straight-through cable is used, NIC Auto Detection

must be enabled in Programs 10-12-05 (GCD-CP10), 84-
05-02 (VOIPU) or 85-01-03 (SHUBU).
UNIVERGE SV9100
Figure 6-22 NEC
Switch.
Installing SV9100 Optional Equipment