Led Indications; Active Led - Green - NEC Univerge SV9100 Hardware Manual

Issue 1.2
4 - 88
5. Install the Compact Flash drive into slot CN7, make sure the drive is
fully seated in the slot (refer to
Drive).
6.1.3

LED Indications

6.1.3.1 Active LED – Green
The Active LED is controlled by the DSP and indicates the
board operational status.
o
o
o
o
Figure 4-27 Install the SO-DIMM Memory
Figure 4-28 Install the Compact Flash
Figure 4-28 Install the Compact Flash Drive
Off: Power off.
On: Reset.
Slow Flash: Board is running but not in sync with the chassis
yet.
Fast Flash: Board is in sync with the chassis and operating
normally.
UNIVERGE SV9100
Installing the SV9100 Blades