NEC Univerge SV9100 Hardware Manual page 417

UNIVERGE SV9100
System Hardware Manual
4. Strip one end of the cable to be connected to the control relay or door
box so that approximately 1/4" (8 mm) of bare wire is exposed.
5. Insert the cable into the proper CN4 or CN5 location while holding down
the lock button (holding down this lock button is easiest with a flat-head
screwdriver). Once the cable is in place, release the lock button.
Refer to the specific function being connected for more detail on PGD(2)-U10
.
ADP connections.
Issue 1.2
6 - 5