Installation - NEC Univerge SV9100 Hardware Manual

UNIVERGE SV9100
System Hardware Manual
Two USB 1.0 ports for USB keyboard support, database backup and
p
software upgrades
One 15-pin VGA connector for VHA monitor support
p
6.1.2

Installation

Only one CD-VM00 can be installed per system.
1. Wear a grounding strap while handling the CD-VM00 and lay it on a
flat workspace.
2. Mount the CR-2032 battery with the + side up in the BATT slot on the
CD-VM00 (refer to
3. To Install the SO-DIMM memory on the CD-VM00 blade, insert the
end with the brass connectors into the CN14 1 slot first.
4. Push the other end down until the lock on both sides locks into place
(refer to
 Handle the CF drive carefully. To prevent damage, do
not drop the drive or apply pressure to it.
 This unit makes extensive use of CMOS technology
and is very susceptible to static; extreme care must be
taken to avoid static discharge when handling
Figure 4-26 Install the CR-2032
Figure 4-26 Install the CR-2032 Battery
Figure 4-27 Install the SO-DIMM Memory on page
Issue 1.2
Battery).
4-88).
4 - 87