NEC Univerge SV9100 Hardware Manual page 172

Issue 1.2
4 - 18
 Number of mail boxes : 896
 System Program and System Data Storing Memory Circuit
 SD card/USB Interface Circuit
 Ethernet Interface Circuit
 GPZ-BS10/GPZ-BS11 Interface Circuit
Main Processing 32-Bit CPU Circuit (P1015 @

Time Switch, Optional Blade Control Circuit

Backboard Interface Circuit

The GCD-CP10 provides:
 400 trunk ports maximum
 896 extension ports maximum
– 896 ports digital/IP extensions maximum
– 368 analog ports maximum
512 virtual extensions

Connection for GPZ-IPLE Daughter Board

Supports TAPI 2.x

 One Green Status LED
 Four Red Status LEDs
 Five diagnostic LEDs which indicate the status of various system
functions
 During normal operation, the "RUN" LED will be flashing and the
remaining LEDs are off
 Time Division Multiplex Switch (TDM Switch)
 Digital Phase Locked Loop (DPLL)
 Tone Generator
 Tone Processing DSP
 Connection for Memory Module
 Digital Signal Processor (DSP)
 DTMF Tone Sender
 DTMF Tone Receiver
 Dial Tone Generator (DTG)
 The GPZ-BS10 provides 64 channelsfor Telephony Resources (e.g.for
DTMF Receiver, Caller ID Receiver, and Call Progress Tone Detection)
 System Tone Sender
 MF Receiver
UNIVERGE SV9100
MHz)
533
Installing the SV9100 Blades