Installation; Led Indications - NEC Univerge SV9100 Hardware Manual

UNIVERGE SV9100
LED Indication
Live LED Busy LED
(Green) (Red)
On On
Flash (1s) On
Flash (1s)
On
Flash
(100ms)
Off
On
Off
Off
Flash (100ms
On/Off)
System Hardware Manual
5.1.2

Installation

Install the COIU blade into an available slot in the chassis. (Refer to
Figure 4-14 GCD-4COTA Blade on page 4-53
blade.)
If the GPZ-4COTE is to be used, install this prior to inserting the
.
GCD-4COTA blade into the chassis.
5.1.3

LED Indications

LED indications for the GCD-4COTA are listed in
GCD-4COTA LED
function and LED and Operational status. Refer to
GCD-4COTA Blade on page 4-53
blades.
Table 4-27 GCD-4COTA LED Indications
Operation Status
System Initializing
The assignment of the unit is refused.
Trouble found during self-diagnostics.
A Channel is busy (use
Normal
another from CH1 ~ CHx).
Operation
All channels are idle.
A Channel is busy (use
Unit Busy
another from CH1 ~ CHx).
All channels are idle.
Downloading firmware.
Indications. Each LED is listed with its associated
for the location of the LEDs on the
–
When you exceed the system
capacity.
When the main software
version is not matched.
–
–
–
–
–
–
Issue 1.2
for a layout of the
Table 4-27
Figure 4-14
Remarks
4 - 55