Led Indications - NEC Univerge SV9100 Hardware Manual

UNIVERGE SV9100
LED Indication
Live LED Busy LED
(Green) (Red)
On On
Flash (1s) On
Flash (1s)
On
Flash
(100ms)
Off
On
Off
Off
Flash 80ms
(On/Off) x 3/
400mS off
System Hardware Manual
3. Connect the cable from the NT1 Network Termination cable to
the CN7 or CN8 connector on the GCD-2BRIA blade and/or
PZ-2BRIA daughter board. (Refer to
Blade on page 4-61
blade.)
5.3.3

LED Indications

LED indications for the GCD-2BRIA are listed in
GCD-2BRIA LED
function and LED and Operational status. Refer to
GCD-2BRIA Blade on page 4-61
blade.
Table 4-32 GCD-2BRIA LED Indications
Operation Status
System Initializing
The assignment of the unit is refused.
Trouble found during self-diagnostics.
A Channel is busy (use
Normal
another from CH1 ~ CHx).
Operation
All channels are idle.
A Channel is busy (use
Unit Busy
another from CH1 ~ CHx).
All channels are idle.
Downloading firmware.
With normal operation, the status LED

flashes fast. If trouble was found during
the self diagnostics routine, the status LED
flashes slow.
Once connected, the PKG LED will not be

indicated for the status of Layer 1
for the location of the connectors on the
Indications. Each LED is listed with its associated
for the location of the LEDs on the
When you exceed the system
capacity.
When the main software
version is not matched.
–
–
–
–
–
–
Issue 1.2
Link.
Figure 4-16 GCD-2BRIA
Table 4-32
Figure 4-16
Remarks
–
4 - 63