Cabling - NEC Univerge SV9100 Hardware Manual

UNIVERGE SV9100
S
S 5
YSTEM
ECTION
5.1
System Hardware Manual
R
EQUIREMENTS AND

Cabling

This section provides cabling requirements and specifications for various
equipment used in the SV9100 system.
Figure 2-4 Connecting the DLC Using Twisted 2-Pair Cable
chassis connected with each of the multiline terminals and single line
telephones by a separate twisted 1-pair cable or 2-pair cable (only for Multiline
Terminals).
DLC
Figure 2-4 Connecting the DLC Using Twisted 2-Pair Cable
Refer to the following tables for cabling requirements and specifications.
Table 2-12 DT300 Series Loop Resistance and Cable Length

Table 2-13 DT400 Series Loop Resistance and Cable Length

Table 2-14 DT700 Series Loop Resistance and Cable Length

Table 2-15 DT800 Series Loop Resistance and Cable Length

Table 2-16 Cable Connection Between the Analog Port and the Single Line

Equipment
Table 2-17 Cabling Requirements

Table 2-12 DT300 Series Loop Resistance and Cable Length
Terminal or Adapter
DTL-2E-1 (BK) TEL
DTL-6DE-1 (BK) TEL
DTL-8LD-1 (BK) TEL
DTL-8LD-1 (WH) TEL
DTL-12BT-1 (BK) TEL
DTL-12PA-1 (BK) TEL
S
PECIFICATIONS
Twisted 2-Pair Cable
By Twisted 1-Pair By Twisted 1-Pair
Cable (without Cable (with AC
AC Adapter)
24 AWG
1,969 ft (600m) 6,562 ft (2000m)
1,969 ft (600m) 6,562 ft (2000m)
1,969 ft (600m) 6,562 ft (2000m)
1,969 ft (600m) 6,562 ft (2000m)
1,969 ft (600m) 6,562 ft (2000m)
Issue 1.2
is a diagram of the
RJ-11
Multiline Terminal
Adapter)
24 AWG
2 - 17