Install Multiline Terminals; Connecting The Dt300/Dt400 Series Multiline Terminal To The System; Connecting The Handset; Handset Connection Dt300 - NEC Univerge SV9100 Hardware Manual

UNIVERGE SV9100
I
S 4
NSTALL
ECTION
4.1
System Hardware Manual
M T
ULTILINE ERMINALS
Connecting the DT300/DT400 Series Multiline Terminal to the
System
This instruction applies to all DT300/DT400 Series Multiline Terminals.
4.1.1

Connecting the Handset

Confirm the location of the handset connector on the bottom of the
multiline terminal. Then, connect the handset to the multiline terminal
using the steps shown below.
4.1.1.1

Handset Connection DT300

1.
2.
Figure 5-30 Installing the Handset (DT300)
4.1.1.2

Handset Connection DT400

1.
2.
Install the modular plug (attached to the curl cord of the
handset) into the handset connector at the back of terminal.
Push until it snaps into place.
Lead the Handset cable through the applicable groove. Refer
to Figure 5-30 Installing the Handset
Install the modular plug (attached to the curl cord of the
handset) into the handset connector at the back of terminal.
Push until it snaps into place.
Lead the Handset cable through the applicable groove. Refer
to Figure 5-31 Installing the Handset (DT400) on page
Issue 1.2
(DT300).
5-44.
5 - 43