Installation; Connectors - NEC Univerge SV9100 Hardware Manual

UNIVERGE SV9100
System Hardware Manual
5.2.2

Installation

To install the GPZ-4COTE
1. Four plastic spacers are included with the COIDB. Install the
plastic spacers on the GCD-4COTA or GCD-LTA blade. Make
sure to attach the spacers so that they extend out on the side of
the daughter board which has the CN1 connector.
2. Position the GPZ-4COTE CN1 connector over the CN4
connector on the GCD-4COTA or GCD-LTA. Press the blades
together, ensuring the plastic spacers lock in place.
3. Install the GPZ-4COTE blade (refer to
the GPZ-4COTE Daughter Board on page 4-57
5.2.3

Connectors

Table 4-30 GPZ-4COTE RJ-61 Cable Connector Pin-Outs on page
4-59 shows the pin-outs for the RJ-61 connector. Refer to
4-15 Installing the GPZ-4COTE Daughter Board on page 4-57
illustration showing the location of the connectors on the
GPZ-4COTE blades.
Table 4-30 GPZ-4COTE RJ-61 Cable Connector Pin-Outs
The CN2 connector is polarity sensitive (tip-to-tip, ring-to-ring).
:
RJ-61 Cable Connector
CN2, Trunks – Connecting to COIU Blade
Pin No.
1
2
3
4
5
6
7
8
Issue 1.2
Figure 4-15 Installing
).
Figure
for an
Connection
Circuit 8 – Tip
Circuit 7 – Tip
Circuit 6 – Tip
Circuit 5 – Ring
Circuit 5 – Tip
Circuit 6 – Ring
Circuit 7 – Ring
Circuit 8 – Ring
4 - 59