NEC Univerge SV9100 Hardware Manual page 173

UNIVERGE SV9100
System Hardware Manual
 MF Sender
 MFC Tone Sender
 MF Signal Sender (Sends caller information to CO for E911)
 Call Progress Tone Detection
 C-Channel Control
Conference: 64 Channels (when built-in modem is enabled), or

96 channels (when built-in modem is disabled)
Caller ID Receiver; 32 Channels

 A load switch which is used for initial system startup, resetting the
system, or when upgrading system software
 One Serial Port (null modem/cross-over cable required)
 One USB Port – USB 1.1/2.0
Memory size - minimum of 32MB (normally 512MB or 1GB) should be
.
used.
USB device power consumption is less than 200mA (1W)
.
 One Gbit Ethernet Port for VoIP function
 One CompactFlash Card Slot
 Background Music/EXSP Control Port
 Status LED
 Two Audio Input/Output terminals
 One Music on Hold External Source
 BGM LED
 EXSP Control LED
 Two Audio Input/Output Terminals
 One General Purpose Control Terminal
 One Music On Hold External Source
 HDLC Packet Processing
 Real Time Clock (tolerance 30 seconds/month)
 Internal MOH Generation
 Call Control Server (ex: Conference Bridge Server, Voice Mail Server,
SIP Server, RTP Forwarding, VoCoder Conversion)
 One lithium battery (CR2032 or equivalent) which provides battery
back-up of system data and RAM memory for approximately 30
months.
The GCD-CP10 functions provided are:
Issue 1.2
4 - 19