Rb) Re-Installing The Sas Hot-Swap Backplane (Hsbp) Board; Figure 54: Re-Attaching The Front Bezel - Kontron CG2300 Installation And Maintenance Manual

6.3

(RB) Re-Installing the SAS Hot-Swap Backplane (HSBP) Board

When handling the SAS backplane board, observe the normal safety and ESD precautions. See "Appendix A: Safety Information"
for more information.
The six-slot SAS backplane board is held in place by a cover plate on top of the HDD bay assembly that goes over the top edge of
the backplane board. There is also a black plastic air duct surrounding the drive bay on the right side and rear of the assembly.
To re-install the SAS backplane board:
1. Re-connect the four SAS HDD cables to the HSBP board. For instructions, see (RE) in Chapter 6.
2. Re-install the SAS backplane board and air duct. (Figure 55, "A" and "B").
79

Figure 54: Re-Attaching the Front Bezel

Installation and Maintenance Guide
www.kontron.com