2.
Install the eUSB module onto the server board by plugging the 2x5 header on the eUSB module onto the server board USB
header ("A").
3.
Press down on the eUSB module, using one finger on each side of the module' s mounting hole, to snap the eUSB module
securely in place. You will know if the module is not properly seated (snapped in place) if the module is angled instead of flat
and parallel with the baseboard.
4.
Fasten the eUSB module using the white plastic standoff on the baseboard. See Figure 38.
5.
Re-install the left riser card assembly, the battery backup assembly, and the chassis cover. For instructions, see (RK), (RI),
and (RL) in Chapter 6.
6.
If this is the last task you are performing, plug in the power cord(s) and re-attach any peripheral devices.
58
Figure 38: Installing an eUSB Flash Module on the Server Board
Installation and Maintenance Guide
www.kontron.com