Rk) Re-Installing A Riser Card Assembly; Re-Installing The Left Riser Card Assembly; Figure 60: Re-Installing The Processor Air Duct - Kontron CG2300 Installation And Maintenance Manual

6.12

(RK) Re-Installing a Riser Card Assembly

This procedure covers both the right and left riser card assemblies.
6.12.1

Re-Installing the Left Riser Card Assembly

To re-install the riser card assembly:
1. Position the riser front tabs over the holes on the PCI support cross bar. (Figure 61).
2. Using the blue touch points on the top of the assembly ("A"), press down to mate the riser card with the header on the
server board ("B", slot 2 for the left-side riser)
87

Figure 60: Re-Installing the Processor Air Duct

Installation and Maintenance Guide
www.kontron.com