Table of Contents
Advertisement
ESD Sensitive Device!
Take all necessary ESD protection measures.
1.
Holding the handle, insert an MSP-Node.
2.
Push it in until the safety lock locks in place. The ID LED becomes steady blue and then turns off during BMC
initialization.
3.
After BMC initialization, the power LED of the MSP-Node becomes steady green: the servers are powered on and
ready to use.
2.3. SYSTEM BEHAVIOR UPON HOT SWAP
The system is electrically designed to support a surprise extraction. However, this type of
extraction is not recommended and could affect system performance and functionalities.
When a hot swap procedure is performed on an MSP802x, the following systems and functionalities could be affected:
All MSP-Nodes: Node-dedicated applications could be affected.
www.kontron.com
MSP8020 Series User Guide Rev. 1.1
// 21
Advertisement
Table of Contents
