4.10 (I) Removing the Front Bezel
The front bezel has to be removed in order to perform tasks such as:
»
Installing or removing hot-swappable hard disk drives or an SD flash card
»
Observing the individual hard disk drive activity/fault indicators
»
Replacing the control panel LED/switch board
NOTE: The system does not have to be powered down just to remove the front bezel.
1. Loosen the captive bezel retention screw on the right side of the bezel (Figure 17, "A").
2. Rotate the bezel to the left to free it from the pins on the front panel, ("B") and remove it.
37
Figure 16: Removing the Backplane Board
Installation and Maintenance Guide
www.kontron.com