3.1.2
Installing a Hard Drive in a Carrier
1. If the drive carrier is empty (that is, if you are installing a drive in it for the first time), remove the black plastic filler panel by
unfastening the four screws that attach it to the carrier. (Figure 2, "A").
Set the screws aside for use with the new drive.
2. If a drive is already installed (that is, if you are replacing the drive), remove it by unfastening the four screws that attach the
drive to the drive carrier. (Figure 2, "A")
Set the screws aside for use with the new drive.
3. Lift the drive (or filler panel) out of the carrier. ("B")
17
Figure 1: Removing the Drive Carrier
Figure 2: Removing a Hard Drive
Installation and Maintenance Guide
www.kontron.com