Configuring Jumpers On The Server Board; Figure 28: Installing A Heat Sink - Kontron CG2300 Installation And Maintenance Manual

Installation and Maintenance Guide

Figure 28: Installing a Heat Sink

5.2.6

Configuring Jumpers on the Server Board

The jumpers are located on the S2600CW2SK server board.
Before you can work with the jumpers defined in this section, you must first remove the chassis cover, right riser card assembly
and processor air duct. For instructions, see (A), (B2) and (C) in Chapter 4.
The other components on the server board can remain in place.
The server board has several 3-pin jumper blocks that can be used to configure, protect, or recover specific features of the server
board. This section shows the jumper blocks available and what they do. For detailed information about using these jumpers, see
Sections 7.3 through 7.7.
Pin 1 on each jumper block is identified by this symbol on the silkscreen: ▼
Figure 29 shows the jumper blocks.
48 www.kontron.com