Installing The Rmm4 Lite Key; Figure 35: Installing And Securing The Riser Card Assembly - Kontron CG2300 Installation And Maintenance Manual

8. Using the two blue touch points, install the riser card assembly into its slot (slot 2 or slot 6) on the baseboard. (Figure
35, "A")
9. Secure the riser card assembly by tightening the captive screws ("C" and "D").
10. Re-install the riser card assembly and the chassis cover. For instructions, see (RK) and (RL) in Chapter 6.
11. If this is the last task you are performing, plug in the power cord(s) and re-attach any peripheral devices.
5.2.11

Installing the RMM4 Lite Key

The Remote Management Module (RMM) solution for the CG2300 server uses RMM4 in the iBMC on the S2600CW2SK server
board.
Before you can install the RMM4Lite key, you must first remove the chassis cover and the left riser card assembly. For
instructions, see (A) and (B1) in Chapter 4.
To install the RMM4 lite key:
55

Figure 35: Installing and Securing the Riser Card Assembly

Installation and Maintenance Guide
www.kontron.com