Figure 49: Removing The Air Duct From The Backplane Board; Figure 50: Re-Attaching The Backplane Board To The Air Duct - Kontron CG2300 Installation And Maintenance Manual

Installing the New SAS Backplane Board
: The complete procedure for reassembling the backplane board, cables, air duct, and cover plate is (RB) in Chapter 6.
NOTE
1. Attach the HDD air duct to the new SAS backplane board using the two retained screws. (Figure 50, "A" and "B"))
2. Connect the four cables into the back of the backplane board. Be careful that the HSBP I
on the corner of the backplane board or the air duct. For instructions, see (RE) in Chapter 6.
3. Secure the six-slot HDD backplane in place with the cover plate, lock in the hard drives, re-attach the front bezel and the
chassis cover. For instructions, see (RB) in Chapter 6.
4. If this is the last task you are performing inside the server chassis, plug in the power cord(s), and re-attach any peripheral
devices.
73

Figure 49: Removing the Air Duct from the Backplane Board

Figure 50: Re-Attaching the Backplane Board to the Air Duct

Installation and Maintenance Guide
C/HDD LED cable does not catch
2
www.kontron.com