Figure 40: Removing The Front Panel Board From The Chassis - Kontron CG2300 Installation And Maintenance Manual

Save the screws for reuse with the new replacement FP board.
Installing the New Front Panel Board
1. Tilt the new FP board and slide it toward the front of the chassis so the RJ45 COM2 and USB connectors fit through the
slot on the front panel of the chassis and the two keyhole slots fit over the standoffs on the front panel board shelf
bracket. (Figure 41 "A" and "B").
2. Replace and tighten the screws on the board to secure the board to the front panel shelf bracket. ("C")
60

Figure 40: Removing the Front Panel Board from the Chassis

Installation and Maintenance Guide
www.kontron.com