2.
Slide the cover forward until it clicks into place. ("A")
3.
Install the shipping screw if tooled entry is required or if the unit will be shipped. ("B")
4.
Replace the two shoulder screws (one on each side) to fasten the cover to the chassis frame. ("C")
5.
Torque screws to 8 lb*in.
6.
Reconnect all peripheral devices and the power cord(s).
CAUTION: This unit must have the cover installed when it is running to ensure proper cooling.
90
Figure 63: Re-Attaching the Chassis Cover
Installation and Maintenance Guide
www.kontron.com