: To avoid damaging the card edge, be sure that the card is lined up straight with the header, not on an angle.
NOTE
3. Align and then tighten the blue captive retention screws at the front of the assembly with the holes on the support cross
bar ("C") and on the rear of the chassis. ("D".
4. Replace the chassis cover. For instructions see (RL) here in Chapter 6.
6.13
(RL) Re-installing the Chassis Cover
When you are finished working inside the chassis, always put the cover back on before powering on the server again. This step is
required to ensure proper cooling.
1.
Starting from the rear of the chassis, align the tab on the rear right edge of the cover with the lock bracket on the
outside of the rear panel and place the cover down over the chassis with the side edges outside the chassis walls.
(Figure 63)
89
Figure 62: Re-Installing the Right Riser Card Assembly
Installation and Maintenance Guide
www.kontron.com