Reassembling Server Components; Before Beginning These Tasks; Tools And Supplies Needed; System References - Kontron CG2300 Installation And Maintenance Manual

6

Reassembling Server Components

6.1

Before Beginning These Tasks

Before working with the server product, pay close attention to the safety instructions provided in this manual. See Appendix A,
"Appendix A: Safety Information"
: Electrostatic discharge (ESD) and ESD protection: ESD can damage disk drives, boards, and other parts. We
WARNING
recommend that you perform all procedures in this chapter only at an ESD workstation. If one is not available, provide some ESD
protection by wearing an antistatic wrist strap attached to chassis ground (any unpainted metal surface) on the server when
handling parts.
Except where noted, the tasks in this chapter require the server to be turned off and the power cord(s) and any peripheral
NOTE:
devices attached to the server disconnected.
6.1.1

Tools and Supplies Needed

» #1 and #2 Phillips (cross-point) screwdrivers (or interchangeable tip screwdriver with #1 and #2 Phillips bits)
» Personal grounding device such as an anti-static wrist strap and a grounded conductive pad
6.1.2

System References

All references to left, right, front, rear, top, and bottom assume that you are facing the front of the server, as it would be
positioned for normal operation.
6.2

(RA) Re-Installing the Front Bezel

The server does not have to be powered down just to reinstall the front bezel.
NOTE:
1. Insert the tabs on the left side of the bezel into the slots on the front panel of the chassis.
2. Move the bezel toward the right and align it on the front panel pins. (Figure 54, "A")
3. Snap the bezel into place and tighten the retention screw to secure it. ("B")
78
Installation and Maintenance Guide
www.kontron.com