Table of Contents
Advertisement
5.
Lock in all the hard drives so they engage with the backplane.
6.
Re-attach the front panel bezel and the chassis cover. For instructions, see (RA) and (RL) in Chapter 6.
7.
If this is the last task you are performing inside the server chassis, plug in the power cord(s), and re-attach any peripheral
devices.
6.4
(RC) Re-Installing the Cable Bundle Bracket and Fan Cage
The cable bundle bracket is under the support cross bar and just behind the fan cage. It is attached to the fan cage by two small
screws. Because both of these components need to be removed and are fastened together, they are treated as one assembly.
To re-install the cable bundle bracket and fan cage:
1.
Fasten the fan cage (with the cable bracket attached) to the chassis floor using the two screws set aside when it was
removed.
81
Figure 56: Re-Attaching the Cover Plate
Installation and Maintenance Guide
www.kontron.com
- Quick Links:
- Using the Bios Setup Utility
Hide quick links:
Advertisement
Table of Contents
