Figure 48: Removing The Server Board - Kontron CG2300 Installation And Maintenance Manual

Removing the Old Server Board
1. Loosen all nine screws holding the server board to the chassis and save them for use with the new server board. See
Figure 48 "A" for the location of these screws.
2. Unscrew the standoff for the eUSB module and save it for reuse with the new server board.
3. Tilt the server board up at the front edge and lift it from the chassis being careful to clear the rear panel of the chassis.
(Figure 48, "B" and "C")
Installing the New Server Board
1. Set the replacement server board in place.
Insert the rear edge of the board first and line up the I/O ports with the slots in the rear panel of the chassis.
71

Figure 48: Removing the Server Board

Installation and Maintenance Guide
www.kontron.com