Rg) Re-Connecting The Baseboard Power Cables - Kontron CG2300 Installation And Maintenance Manual

Baseboard to Front Panel Board Signal Cables
These cables all have a baseboard connection and a front panel board connection.
SSI Front Panel Board Cable
The SSI front panel board signal cable connects the front panel board connector (J1) with the baseboard (SSI_FRONT_PANEL,
J1A2).
For the location of the baseboard SSI front panel board connector, see Figure 12: Cable Routing" in (E) in Chapter 4.
For the location of the SSI power control signal connector on the FP board, see Figure 39 in Section 5.2.14.
Serial Cable
The serial cable is part of the multifunction front panel board power and signal cable As part of the multifunction front panel
board cable, along with the HDD LED cable and COM2, the serial cable interconnects the front panel board (FP board) with the
fan control board, the baseboard, and the HDD LEDs.
For the location of the multifunction cable connector on the FP board (J1A1), see Figure 39 in Section 5.2.14.
For the location of the serial connector on the baseboard (SERIAL_A), see Figure 12: Cable Routing" in (E) in Chapter 4.
Front Panel Board USB Cable
The front panel board USB cable connects the baseboard to the FP board to provide USB 2.0 signals.
For the location of the baseboard USB connector (USB-5-6, J1K1), see Figure 12: Cable Routing" in (E) in Chapter 4.
For the location of the USB connector on the FP board (J4), see Figure 39 in Section 5.2.14.
Other Baseboard Signal Cables
IPMB/Fan Cable
I 2 C
The IPMB cable (aka Fan I C) connects the baseboard with the fan control board (FCB) to provide fan control signals.
2
For the location of the IPMB connector (J1D4) on the baseboard, see Figure 12: Cable Routing" in (E) in Chapter 4.
For the location of the FCB I
HSBP I 2 C Cable
The HSBP I 2 C cable connects the HDD HSBP (hot-swap backplane) to the baseboard and the front panel board to provide HDD
LED signal control on the disk drive carriers and on the system front panel.
For the location of the HSBP I
For the location of the HSBP I
For the location of the HSBP I
6.8

(RG) Re-Connecting the Baseboard Power Cables

The four baseboard power side cables all run from the power distribution board, across the cable bundle bracket in a protective
cover, to their connectors on the baseboard.
Main Power
The baseboard SSI main power cable provides power to the baseboard and the power supply with the "PS-ON" signal from the
power distribution board. The cable is soldered to the PDB and connected to MAIN_PWR (J9G1).
For the location of the connector on the baseboard, see Figure 12: Cable Routing" in (E) in Chapter 4.
To reconnect the main power cable:
1. Run the cable bundle across the cable bundle bracket and connect it to the baseboard.
2. If present, re-cover with the black insulator covering.
83
C connector (J8A1), see Figure 43 in Section 5.2.17.
2
2 C connector (J2) on the HDD backplane, see Figure 55 here in (RB) Chapter 6.
C/HDD LED connector (HDD-LED) on the FP board, see Figure 39 in Section5.2.14.
2
2 C connector (J1D3) on the baseboard, see Figure 12: Cable Routing" in (E) in Chapter 4.
Installation and Maintenance Guide
www.kontron.com