Parallel Rom Interface - LSI LSI53C875A Technical Manual

2.3 Parallel ROM Interface

2-48
send command, the first byte of the data send command is assumed to
be the high-order byte and is "married" with the low-order byte stored in
the lower byte of the
two bytes are sent across the SCSI bus. For "N" consecutive wide data
send Block Move commands, the first through the (N
instructions should be Chained Block Moves.
CHMOV 5, 3 when Data_Out
Moves five bytes from address 0x03 in the host memory to the SCSI bus.
Bytes 0x03, 0x04, 0x05, and 0x06 are moved and byte 0x07 remains in
the low-order byte of the
is married with the first byte of the following MOVE instruction.
MOVE 5, 9 when Data_Out
Moves five bytes from address 0x09 in the host memory to the SCSI bus.
The LSI53C875A supports up to one megabyte of external memory in
binary increments from 16 Kbytes, to allow the use of expansion ROM
for add-in PCI cards. This interface is designed for low speed operations
such as downloading instruction code from ROM; it is not intended for
dynamic activities such as executing instructions.
System requirements include the LSI53C875A, two or three external
8-bit address holding registers (HCT273 or HCT374), and the
appropriate memory device. The 4.7 k pull-up resistors on the MAD bus
require HC or HCT external components to be used. If in-system Flash
ROM updates are required, a 7406 (high voltage open collector inverter),
a MTD4P05, and several passive components are also needed. The
memory size and speed is determined by pull-up resistors on the
8-bit bidirectional memory bus at power-up. The LSI53C875A senses this
bus shortly after the release of the Reset signal and configures the
Expansion ROM Base Address
machines for the appropriate conditions.
The external memory interface works with a variety of ROM sizes and
speeds. An example set of interface drawings is in
Memory Interface Diagram Examples."
Functional Description
SCSI Output Data Latch (SODL)
SCSI Output Data Latch (SODL)
register and the memory cycle state
register before the
th
– 1) Block Move
register and
Appendix B, "External