Safety Measures At The Place Of Installation; Dangers Through Consumables - Leibinger JET3 User Manual

Group 2

2.9 Safety measures at the place of installation

Mains connection!
The device has no mains switch and must only be connected to a plug
socket in the direct vicinity of the place of setting up!
Caution – risk of explosion!
The device must not be operated in rooms where there is a risk of
explosion!
Installation of the device
The device must be installed in a well ventilated room only and must
be kept away from any source of heat, flame or sparks, e.g. radiant
heater, etc.
A place of setting up must be selected with sufficient load bearing
capacity and stability. When setting up it must be observed that
sufficient movement space is available for the operating and service
personnel. Solvents are processed in the device, sufficient room
ventilation must be ensured!
Prior to assembly the place of setting up must be cleaned of dirt and
contamination (residue of lubricants etc.). The working place
surroundings should be kept clean at all times in order to ensure
unrestricted access to the LEIBINGER-JET3 device.

2.10 Dangers through consumables

Inks are coloured liquids on a solvent basis. The safety instructions on the containers of
the consumables as well as the instructions in the group Accident prevention must be
especially adhered to in order to exclude dangers for persons and the surroundings.
Further instructions can be found in the Safety Data Sheets.
When handling consumables (inks/solvents) the danger instructions
and safety advice on the containers (transport, storage, distribution
and correct disposal) must be observed!
Release R1.03e
Safety instructions Page 18
LEIBINGER JET3