Leibinger JET3 User Manual page 100

Group 7
Figure 51
Setting position
Left angle of charging tunnel
Target result
Jet adjustment (Step 3)
15 – Charging tunnel
16 – Deflection plates
In this position check the setting position again. The ink jet should be now in the
centre of the charging tunnel and parallel to the deflection plates. If necessary
the position has to be corrected again by moving the fixing plate.
If you have reached the correct setting you have to close the nozzle seal. For
this press on the arrow button <Close nozzle> (19) and keep it pressed until
the nozzle seal is completely closed.
Finally activate the ink jet monitoring with the button <Ink-Flow-Sensor active>
(20).
An activated jet monitoring is marked by a ... on the button.
Close the menu with the button <Close> (21).
Release R1.03e
Data/Programming
16
16
15
17
17
End position
17 – Holding screw of the fixing plate (5x)
18 – Arrow button <Open nozzle>
17
18
LEIBINGER JET3
Page 100