Safety Measures At The Place Of Installation; Dangers Through Consumables - Leibinger Jet 2 Manual

Group 2

2.10 Safety measures at the place of installation

Mains connection!
The device has no mains switch and must only be connected to a
plug socket in the direct vicinity of the place of setting up!
Caution – risk of explosion!
The device must not be operated in rooms where there is a risk of
explosion!
Installation of the device
The device must be installed in a well ventilated room only and must
be kept away from any source of heat, flame or sparks, e.g. radiant
heater, etc.
A place of setting up must be selected with sufficient load bearing
capacity and stability. When setting up it must be observed that sufficient
movement space is available for the operating and service personnel.
Solvents are processed in the device, sufficient room ventilation must be
ensured!
Prior to assembly the place of setting up must be cleaned of dirt and
contamination (residue of lubricants etc.). The working place surroundings
should be kept clean at all times in order to ensure unrestricted access to
the LEIBINGER-JET 2 device.

2.11 Dangers through consumables

Inks are coloured liquids on a water or solvent basis. The safety instructions on the
containers of the consumables as well as the instructions in the group Accident prevention
must be especially adhered to in order to exclude dangers for persons and the surroundings.
Further instructions can be found in the Safety Data Sheets.
When handling consumables (inks/solvents) the danger instructions and
safety advice on the containers (transport, storage, distribution and
correct disposal) must be observed!
Release 3.00
Safety instructions Page 23
Leibinger-Jet 2 se