Leibinger JET3 User Manual page 208

Group 9
Error no. Error message
1307 Ink delivery is faulty.
Please check pump and all
connections.
1312 Leakage in hydraulic has
been found. Please check
immediately.
5030 Stroke-Go error
5050 Print-Go distance error
5051 Print-Go error
Release R1.03e
Disturbances/Trouble shooting
Reason of failure
Main pump could not place
the membrane to the central
position within 2,5 sec. dur-
ing the normal operation.
Air in the system.
Leakage.
Bleeding valve
close correctly.
Main pump is defect elec-
trically.
Main pump is defect mech-
anically.
Leakage sensor at the ca-
binet bottom reports liquid.
During a stroke has been
generated, the next stroke
output has been
initiated.
The printing distance (PG-
distance) which is specified
in the job editor between
two prints is smaller than
the print.
During a print
PrintGo-signal has
already received.
Workaround
Activate function perma-
nent bleeding for some
minutes.
Check for leakage
Check bleeding valve and
if necessary replace it.
does not Check main pump and if
necessary replace it.
Check system for liquid
and repair.
Check leakage sensor for
dirt and if necessary clean
it.
Reduce production speed.
Increase font width.
already Use other printing mode
(high speed mode).
Reduce height
printing
amount of dots).
Reduce font width.
Increase the PG-distance
value.
the next Reduce font width.
been Check
(sensor).
Check signal encoder for
multi-identification
a print.
Enlarge product distance.
Page 208
of total
image (Reduce
signal encoder
during
LEIBINGER JET3