Wan Dsl Mode - Draytek Vigor2760 User Manual

Cancel
3. After finished the settings above, click Apply to save the settings then click Cancel to
return to previous page.
4 . 1 . 1 . 1 2 W A N D S L
4 . 1 . 1 . 1 2 W A N D S L
The DSL mode tab is used to configure which xDSL mode is used by the router. Please
configure this according to the DSL type provided by the ISP. The DSL mode configured in
the profiles under the DSL Mode tab will work only if they match the configurations here.
Available parameters are listed below:
Item
Physical Type
DSL Debug Mode
Using custom modem
code
Apply
Clear
Click it to return to previous web page.
M o d e
M o d e
Description
Use the drop down list to specify the physical type of the
WAN interface.
Auto: The router will detect which mode that the ISP is
using. Usually it might be ADSL1/2/2+ or VDSL2.
ADSL AnnexJ: The DSL physical type can be ADSL
Annex J.
ADSL Multimode: The DSL physical type can be ADSL,
ADSL2 or ADSL2+.
VDSL2 only: The DSL interface is fixed with VDSL2 only.
Check it to enable the debug mode to find out the problem
via DSL synchronization.
Different countries adopt different modem codes. If the
default DSL modem firmware (offered by DrayTek) is not
suitable for your request, simply check this box to replace
the DSL modem firmware to get the suitable modem code.
DSL firmware for upload – Choose the DSL module
firmware you want to upload to Vigor router.
Click it to save the settings.
Click it to remove the modification of the web page.
80
Vigor2760 Series User's Guide