Status - Draytek Vigor2760 User Manual

Network
My WAN IP
LAN Interface
Apply
Clear
After finished the settings above, click Apply to save the settings.
4 . 1 1 . 4 S t a t u s
4 . 1 1 . 4 S t a t u s
This page displays the existed VPN profiles for your reference. You can click the Overview,
IPsec, L2TP or PPTP tab to check and choose the VPN profile you want. Next, click Dial to
build the VPN connection between your PC and the remote end.
Phase2 Key Lifetime (min) –For security reason, the lifetime
of key should be defined. The default value is 3600 seconds.
You may specify a value in between 600 and 86400 seconds.
Perfect Forward Secrecy (PFS) –The IKE Phase 1 key will
be reused to avoid the computation complexity in phase 2. The
default value is inactive this function.
Dead Peer Detection –Action – This function will detect if
any response received from the peer. If no response, the chosen
action will be performed. Hold means such VPN connection is
still active; Clear means such VPN connection will be down.
Dead Peer Detection – Delay Time (sec) – It is available
when Clear is selected for Dead Peer Detection above. Set
the interval for the detection. The default setting shall be "30"
seconds.
Dead Peer Detection – Timeout (sec) –It is available when
Clear is selected for Dead Peer Detection above. Set the time
that the system will wait for the response. The default setting
shall be "120" seconds. In default, the detection will be done
for four times within the default time. If there is no response,
the VPN tunnel will be disconnected.
This field is only applicable when you select L2TP as the
server type and enable L2TP over IPsec.
Type the WAN IP address for the VPN tunnel.
Use the drop down list to specify a LAN profile.
Click it to save the settings.
Click it to remove the modification of the web page.
266
Vigor2760 Series User's Guide