Rs-232C Port - IDK MSD-804FD Series Command Manual

3.3.11 RS-232C port

@SCT RS-232C port communication
@SCT, port, setting
Command
format
Return value @SCT, port, setting
format
Parameter port : RS-232C connector
* OUT1B to OUT4B can be set only if Cat5e/Cat6 output option is installed.
setting : Communication settings
•
•
•
•
For set values, see Table 3.3.11a.
Example Send
Receive
Related info. 8.10.1 Communication setting
Note After IP address or serial communication setting is changed, communication may
be disabled. Change the environmental settings of communication based on the
MSD settings after changed.
@GCT Get RS-232C port communication
Command @GCT
format
Return value @GCT, rs_232c_1, rs_232c_2, outB_1, outB_2, outB_3, outB_4
format
Parameter rs_232c_1: Communication settings of RS-232C CH1 port
rs_232c_2: Communication settings of RS-232C CH2 port
outB_1 to 4: RS-232C communication setting of OUTB's each output
* OUT1B to OUT4B can be set only if Cat5e/Cat6 output option is installed.
•
•
•
•
For set values, see Table 3.3.11a.
Example Send
Receive
Related info. 8.10.1 Communication setting
0 = All ports, 1 = RS-232C CH1 port, 2 = RS-232C CH2 port
3 = OUT1B*, 4 = OUT2B, 5 = OUT3B, 6 = OUT4B
Baud rate (4800, 9600, 19200, 38400 [bps] [Default]: 9600[bps]
Data length (8, 7[bit] [Default]: 8[bit])
Parity (NONE, EVEN, ODD [Default]: NONE)
Stop bit (1, 2[bit] [Default]: 1[bit])
@SCT,1,24 Set RS-232C CH1 port as follows:
Baud rate=19200[bps], Data length=8[bit],
Parity=None, Stop bit=1[bit]
@SCT,1,24
Terminated normally.
Baud rate (4800, 9600, 19200, 38400[bps] [Default]: 9600[bps]
Data length (8, 7[bit] [Default]: 8[bit])
Parity (NONE, EVEN, ODD [Default]: NONE)
Stop bit (1, 2[bit] [Default]: 1[bit])
@GCT Get communication settings of RS-232C ports.
@GCT,24,24, RS-232C CH1 port and CH2 port are set as following;
24,24, 24,24
Baud rate:19200[bps], Data length: 8[bit], Parity:
None, Stop bit: 1[bit].
MSD-804FD Users Guide (Command Guide)
77