IDK MSD-804FD Series Command Manual page 93

@SEC Set control command (Display received data)
Command
@SEC, no, delay, port, memo, length, command, timeout, retry, interval, retryover,
format
display, delimiter
Return value
@SEC, no, delay, port, memo, length, command, timeout, retry, interval, retryover,
format
display, delimiter
Parameter no : Command number
1 to 32
delay :
0 to 999999
port: Output port
1 to 262143
Output
connector
Output
connector
Output
connector
Set "1" for the bit corresponding to the output port to which the command is sent
(Since bit 23 to 19 are not used, always specify "0"). For example, if you send a
command to RS-232C CH1, specify "1"(0000000000000001 in binary). If sending a
command to LAN 1 and LAN 2, specify "192"(000000000000000011000000 in
binary).
Can be set only if Cat5e/Cat6 output option is installed.
memo:
Up to 14 characters of 20 to 7D except 2C (,). "2 ASCII codes"
length : Data size of the sent command (the number of bytes)
0 to 30
command : Send command data
Specify length × 2 digits with 0 to 9, A to F, a to f = 4 bit per digit (in
hexadecimal)
timeout :
0 to 99999
retry :
0 to 99
interval : Interval between retries
0 to 99999
retryover : Processing at retry timeout
0 = Stop processing, 1 = Continue processing
display : Displaying received data
1 = In ASCII codes, 2 = In hexadecimals
delimiter:
Specify 2 digits of 0 to 9, A to F, a to f = 4 bit per digit (in hexadecimal) in order
to monitor delimiters
100 = Not monitor
bit6 bit5 bit4
RS-232C RS-232C
LAN1
OUT4B OUT3B
bit14 bit13 bit12
LAN
LAN8 LAN7
OUT1B*
-
-
93
MSD-804FD Users Guide (Command Guide)
bit3 bit2
RS-232C RS-232C
RS-232C
OUT2B OUT１B
bit11 bit10 bit9
LAN6 LAN5 LAN4
bit18 bit17
LOOP LAN
BACK OUT4B OUT3B
bit1 bit0
RS-232C
CH2 CH1
bit8 bit7
LAN3 LAN2
bit16 bit15
LAN LAN
OUT2B