IDK MSD-804FD Series Command Manual page 83

Presentation switcher
Hide thumbs Also See for MSD-804FD Series:
Table of Contents

Advertisement

@GBG
Get OUTB gateway address
Command
@GBG
format
@GBG, unit_1, unit_2, unit_3, unit_4
Return value
format
Parameter
unit_1 : Upper bit of the OUTB gateway address to unit_4 : Lower bit of the OUTB
gateway address
0 to 255 = 8 bit (Decimal notation) [Default]: 192.168.001.201
Values can be got only if Cat5e/Cat6 output option is installed.
Example
Send
Receive
Related info.
8.11.3 Gateway address
@SLF
Set LAN operation mode
@SLF, connection, mode (, ip_1, ip_2, ip_3, ip_4, pjlink, tcp, password)
Command
format
Return value
@SLF, connection, mode (, ip_1, ip_2, ip_3, ip_4, pjlink, tcp, password)
format
Parameter
connection : Connection number
1 = Connection 1 to 8 = Connection 8
mode : Operation mode
0 = RECEIVER mode [Default], 1 = TRANSMITTER mode
ip_1 : Upper bit of the destination IP address to ip_4 : Lower bit of the destination IP
address
0 to 255 = 8 bit (Decimal notation) [Default]: 192.168.001.200
Set this parameter only if you select TRANSMITTER mode above.
pjlink : PJLink protocol connection
0 = PJLink not used [Default], 1 = PJLink used
Set this parameter only if you select TRANSMITTER mode above.
tcp : Destination port number
1 to 65535 [Default]: 1100
Set this parameter only if you select TRANSMITTER mode and "0" (PJLink not used)
for pjlink above.
password :
Up to 32 characters of the following ASCII codes: 30 to 39, 41 to 5A, 61 to 7A
(alphanumeric characters). "2ASCII codes"
Set this parameter only if you select TRANSMITTER mode and "1" (PJLink used) for
pjlink above.
If you do not use password authentication to connect the device using PJLink
protocol, you can skip this parameter.
Example
Send
Receive
Send
@GBG
@GBG,192,168,1,254
@SLF,1,0
@SLF,1,0
@SLF,2,1,192,168,1,1,0,1300
83
MSD-804FD Users Guide (Command Guide)
Get gateway address
Gateway address:"192.168.1.254"
Set operation mode of connection 1
to RECEIVER.
Terminated normally.
Set connection 2 as follows:
Option mode: TRANSMITTER,
Destination IP address: 192.168.1.1,
PJLink: Not used, Destination port

Advertisement

Table of Contents
loading

Table of Contents