IDK MSD-804FD Series Command Manual page 85

@GLF Get LAN operation mode
Command @GLF, connection
format
@GLF, connection, mode (, ip_1, ip_2, ip_3, ip_4, pjlink, tcp, password)
Return value
format
Parameter connection : Connection
1 = Connection 1 to 8 = Connection 8
mode : Operation mode
0 = "RECEIVER mode" [Default], 1 = "TRANSMITTER mode"
ip_1 : Upper bit of the destination IP address to ip_4 : Lower bit of the destination IP
address
0 to 255 = 8 bit (Decimal notation) [Default]: 192.168.001.198
Replied only if mode is TRANSMITTER.
pjlink : PJLink protocol connection
0 = PJLink not used [Default], 1 = PJLink used
Replied only if mode is TRANSMITTER.
tcp : Destination port number
1 to 65535 [Default]: 1100
Replied only if mode is TRANSMITTER and pjlink is set to "0" (not used).
password :
Up to 32 characters of the following ASCII codes: 30 to 39, 41 to 5A, 61 to 7A
(alphanumeric characters). "2ASCII codes"
Replied only if mode is TRANSMITTER, pjlink is set to "0" (not used), and password
is set.
Example Send
Receive
Send
Receive
Send
Receive
Send
Receive
Related info. 8.11.4 Operation mode
@GLF,1
@GLF,1,0
@GLF,2
@GLF,2,1,192,168,1,1
,0,1300
@GLF,3
@GLF,3,1,192,168,1,2
,1,PROJECTOR1
@GLF,3
@GLF,3,1,192,168,1,2
,1
85
MSD-804FD Users Guide (Command Guide)
Get operation mode of connection 1.
Operation mode: RECEIVER
Get operation mode of connection 2.
Operation mode: TRANSMITTER, Destination
IP address: 192.168.1.1, PJLink: Not used,
Destination port number:1300
Get operation mode of connection 3.
Operation mode: TRANSMITTER, Destination
IP address: 192.168.1.2, PJLink: Used,
Password: PROJECTOR1
Get operation mode of connection 3.
Operation mode: TRANSMITTER, Destination
IP address: 192.168.1.2, PJLink: Used,
password: not set