Table of Contents
Advertisement
@SEC
Set control command (Control CEC)
Command format
@SEC, no, delay, port, memo, error, ch_1, cec_1 (, ch_2, cec_2
Return value
@SEC, no, delay, port, memo, error, ch_1, cec_1 (, ch_2, cec_2
format
Parameter
no : Command number
1 to 32
delay : Delay time
0 to 999999
port : CEC control
524288 = CEC control
memo:
Up to 14 characters of 20 to 7D except 2C (,). "2 ASCII codes"
.
error : Processing if no reply from destination device
0 = Stop, 1 = Execute (Continue)
ch_1-8 : Output
1 = OUT1A, 2 = OUT2A, 3 = OUT3A, 4 = OUT4A, 5 = OUT1B, 6 =
OUT2B, 7 = OUT3B, 8 = OUT4B*
* Can be set only if Cat5e/Cat6 output option is installed.
cec_1-4 : Control command
0 =Not controlled, 1 = POWER OFF, 2 = POWER ON
If you send a parameter only to the outputs to be controlled, the outputs without
sent parameter are automatically set to "0" (Not controlled). Normally, you do not
need to send the parameter, "0" (Not controlled) for cec_1-4.
Send
Example
Receive
Related info.
8.12.1 Control commands
@SEC,7,0,524288,DISPLAY1
ON,0,1,2
@SEC,7,0,524288,DISPLAY1
ON,0,1,2
97
MSD-804FD Users Guide (Command Guide)
Register as follows to the control
command 7:
・Delay: 0 ms
・Memo: DISPLAY1 ON
・Error: Stop
・Turn on the device connected to
OUT1.
・Not control all other outputs.
･･･
)
･･･
)
Advertisement
Table of Contents
