Table of Contents
Advertisement
7
*
Error codes are replied in the following order:
Video output to HDMI output port, audio output to HDMI output port, audio output
to analog audio output port.
Video output status
Error code
0
Video or audio is output correctly. *
1
－
2
Only replied if digital input, which means DDC power is not input.
(Normally, if input device is not connected, this error code is
displayed)
3
Video signal is not input
4
Only replied if digital input, which means video or audio output of the
source device is muted
5
Only replied if digital input, which means signal with HDCP is input
but display device is HDCP incompliant (This error code may be also
replied during HDCP authorization)
6
Only replied if digital input, which means source device does not
output the required information (packets) for output of video or audio
7
Signal that is not supported by
MSD-804FD (Sampling clock is
out of range) is input.
8
－
9
－
A
Input channel is set to "OFF"
B
-
C
Display device is not connected
D
Authorizing HDCP
E
HDCP authorization failed
F
Cat5e/Cat6 cable is not connected.
7
*
Analog audio input status cannot be detected. Even if "0" is replied, audio may not
be output with analog input selected.
8
*
Status only for OUT1B to OUT4B.
MSD-804FD Users Guide (Command Guide)
Audio output status
7
"@SAM Set output mute (P. 62)"
is set to "ON"
Audio signal is not input
Since compressed audio is input,
audio cannot be output
(Compressed audio can be
output only to display devices
supporting compressed audio).
"@SDO Set audio output
connector (P. 66)" is set to "OFF".
"@SDM Set output mode (P. 51)"
is set to "DVI MODE" or a display
device that does not support
audio is connected.
"@SAOSet digital audio output
connector" (P.67) is set to "OFF".
*
*8
129
*8
Advertisement
Table of Contents
