IDK MSD-804FD Series Command Manual page 76

@GSP Get speaker configuration
Command @GSP, ch
format
Return value
@GSP, ch, number, speaker_1 (, speaker_2
format
Parameter ch : Input channel
1 = IN1 to 5 = IN5
number : Speakers
1 to 8 [Default]: 2
speaker_1-8 : Speakers to be used
0 = Front Left/Right [Default] 1 = Low Frequency Effect,
2 = Front Center, 3 = Rear Left/Right, 4 = Rear Center,
5 = Front Left/Right Center, 6 = Rear Left/Right Center,
7 = Front Left/Right Wide, 8 = Front Left/Right High,
9 = Top Center, 10 = Front Center High
Example Send
Receive
Related info. 8.9.6 Speaker configuration
@RME Copy EDID
Command @RME, out, number (, name)
format
@RME, out, number (, name)
Return value
format
Parameter out : Copy connector
1 = OUT1 to 4 = OUT4
number : number of the saved COPY DATA
1 to 8
name : Name of "COPY DATA"
Up to 10 characters using 20 to 7D. "2 ASCII codes"
The name of the "COPY DATA" can be pretermitted. If pretermitted, EDID setting is
saved without changing currently saved name.
Example Send
Receive
Send
Receive
Related info. 8.9.7 EDID Copy
@GSP,1 Get speakers of IN1
The following 6 speakers are used: Front
@GSP,1,6,0,1,2,3
Left/Right, Low Frequency Effect, Front Center,
Rear Left/Right
Copy the EDID data from the OUT1 monitor and
@RME,1,1
save to COPY DATA 1.
@RME,1,1 Terminated normally.
@RME,3,4,800x600
@RME,3,4,800x600
76
MSD-804FD Users Guide (Command Guide)
･･･
)
Copy EDID data of the OUT3 monitor and
save to COPY DATA 4 named "800x600".
Terminated normally.