Adjusting Brake Pedal Position Sender G100 - Volkswagen Touareg 2010 Workshop Manual

Touareg 2010 ➤
Brake systems - Edition 05.2011
Continuation for both vehicles
– Unscrew bolts -arrows- and remove crash wedge -1- from
mounting bracket -2-.
– Separate brake pedal -3- from brake servo
– Pull split pin -arrow- off pivot pin -1-.
– Pull pivot pin -1- out of mounting.
– Remove brake pedal.
5.2.2 Installing
– Install in reverse order.
Note
Pivot pin fits in one position only.
– Clip brake pedal to brake servo
Specified torque
Component
Crash wedge to mounting bracket
– Remove knee airbag ⇒ General body repairs, in‐
terior; Rep. gr. 69 ; Airbag; Removing and installing
knee airbag .
5.3 Adjusting brake pedal position sender -
G100-
– Remove footwell cover ⇒ General body repairs, interior; Rep.
gr. 68 ; Compartments, covers and trims .
Remove cover on side of dash panel ⇒ General body repairs,
interior; Rep. gr. 68 ; Compartments, covers and trims .
Remove left dash panel cover, driver side ⇒ General body re‐
pairs, interior; Rep. gr. 68 ; Compartments, covers and trims .
Remove right dash panel cover, front passenger side ⇒ General
body repairs, interior; Rep. gr. 68 ; Compartments, covers and
trims .
64
Rep. gr.46 - Brakes - mechanism
⇒ page 62 .
⇒ page 63 .
Specified torque
3 Nm