Assembly Overview - Sliding/Tilting Sunroof With Glass Panel - Volkswagen Passat 2011 Workshop Manual

Passat 2011 ➤ , Passat Variant 2011 ➤
General body repairs, exterior - Edition 06.2019
The opening of the glass panel in sliding -2- or tilting -3- positions
can be preselected using the rotary knob.
On the rotary knob there are marks for preset sliding and tilting
positions of the glass panel.
Opening sliding/tilting sunroof to the so called comfort position
-1-, prevents to a large extent wind noise while driving, which can
occur when sunroof is fully open -2-.
Pre-selector switch
The sliding/tilting sunroof with glass panel is equipped with a force
limitation (roll back) feature while closing. If an obstacle is en‐
countered during closing or opening from the elevating or sliding
position, the glass panel will be moved in the opposite direction.
In addition, there is an emergency closure function. If problems
occur during closure, the sliding/tilting sunroof with glass panel
can be forced to shut by pressing the preselector switch when it
is in the "close sunroof" position -4-.
The roll-back function is disabled when the emergency closure
function is active.
The drive for the sliding/tilting sunroof with glass panel is protec‐
ted against overheating by a time limit. The protective mechanism
activates when the sunroof is operated continuously for approx.
2 minutes. It is functional again after a cooling-off phase.
In the event of power failure, the sliding/tilting sunroof with glass
panel can be moved using a 4 mm hexagon key directly on the
drive.
1.3 Assembly overview - sliding/tilting sun‐
roof with glass panel
Note
With effect from 11.2010 this sliding/tilting sunroof will only be
installed in the Passat saloon.
176
Rep. gr.60 - Sunroof