Mechanical Installation - h/p/cosmos 150/50 mercury Operating And Service Manual

7.4.5

Mechanical installation

Make sure that there is a safety zone of at least 2 x 1 m (L x W) behind and 1 x 1 m in front of the running
N
machine. With the optional function "reversible running belt rotation", a safety zone of 2 m in length and the width
of the running machine in front of the running machine is also nedded.
Put a gymnastic mat (or something similar) in front of and behind the running machine to protect the subject in the
N
event of a fall. Place the device on a rubber mat as large as the device to protect the floor from dust and scratches,
to ensure a firm stand and to reduce noise.
The designated space for the running machine must allow even and horizontal positioning of the device.
N
Models with levelling sockets (adjustable "feet") at the rear of the running machine have to be adjusted so that they
N
have a firm stand to avoid noises such as knocking or rattling during the training. Check the weight load pressure
on the levelling sockets (weight of the running machine at the rear), by trying to lift the frame off the ground at the
rear of the running machine one side after the other. Thus, it can be determined whether the same load is on both
sockets.
The levelling sockets and the front wheels of the elevation system may cause a print in the flooring. Please use
N
h/p/cosmos floor mats to protect sensitive flooring:
Floor protection mat 150/50 for running machines with deck size 150x50 cm [cos14005]
Floor protection mat 170/65 for running machines with deck size 170x65 cm [cos14042]
Floor protection mat 190/65 for running machines with deck size 190x65 cm [cos14043]
Other sizes available on request.
For models without levelling sockets: Make sure that the floor is even and horizontal, and the entire base frame
N
rests on the floor.
For models with a running surface of 200 x 75 cm or larger, ensure that the floor is even and horizontal and that
N
the entire base frame rests on the floor. The device is equipped with levelling sockets, but they should only be
used in case of an uneven floor.
Before switching on the device, de-install the mechanical transportation fuse, which fixes the upper and lower
N
frame.
The transportation locks have to be removed after setup on the h/p/cosmos gaitway model with integrated force
N
plate. Drive elevation up to max of 25 %. Loosen the four M8 screws, marked with the red arrows on the underside
of the aluminum force plates, and remove them. Drive elevation down to 0 %. Loosen the lock nuts at the levelling
sockets. Now level out the running machine with the help of the Kistler software and then tighten the locknuts
again.
After installation or change of location, check and, if necessary, adjust the running belt (see chapter 0 and 8.6 for
N
maintenance instructions), so that it is placed exactly in the middle of the two rollers.
If the running machine has been installed safely and horizontally, it can be plugged in (see chapter 7.4.6 entitled
N
"Electrical installation") and taken into operation.
It is recommended to lubricate the running surface with 40 ml silicone oil before using it for the first time. See
N
separate chapter 8.4 entitled "Lubrication of the running belt / running surface".
© 2012 h/p/cosmos sports & medical gmbh
file: n:\article\cos14310m5-v1_06hpc-en\20120504_cos14310m5-v1.06hpc-en_manual_h-p-cosmos_running_machine.docx
email@h-p-cosmos.com
safety, installation and commissioning
created 04.05.2012 printed 04.05.2012 page: 80 of 191