h/p/cosmos 150/50 mercury Operating And Service Manual page 65

List of user options/optional functions
Option Description
OP01 Reset (deleting) of error messages
Note: This option resets exclusively
the causing variable. If for example
the E.02 service-time-interval is
being set back with this operation,
the distance-interval is not set back
and vice versa! Only administrator
option OP 47 resets all three values
simultaneously.
OP02 Total distance covered (km)
OP03 Indication of total hours of operation
= stand-by-time including runtime of
motor/ running belt (h)
OP04 Indication of total hours of
runtime of motor/running belt (h)
OP05 Indication of firmware version and
date
OP06 Adjustment of actual date and the
real time clock
OP07 Acoustic heart rate signal
OP08 Stop time / deceleration time after
STOP key in relation to the max.
speed
OP09 Start speed (Manual mode or cardio
mode) for feedback after START key
has been pressed.
This value can be reduced to 0.0
km/h for advanced users.
© 2012 h/p/cosmos sports & medical gmbh
Comment / Display
The required maintenance work has to be performed before deleting
error messages. The h/p/cosmos service department has to be
contacted before one of the service displays or error codes will be
deleted!
Confirmation on display
Info: This option only sets back the error message! If the error still
exists, you are not able to set back the error message. In this case
consult an authorised service engineer
The following intervals are set back by this operation:
E.01: Oil-interval A-OP 35
E.02: Service-time-interval A-OP 37
E.02: Service-distance-intervall A-OP 38
§
%
§
%
§
%
=
"
§
%
!
$
minutes, seconds
This function is normally used to control the regularity of the heart rate
or to find reasons for transmitting problems
§
OFF: no acoustic heart-rate-signal
ON: acoustic heart rate signal for every beat
§
$
Adjustable from 2.... 30 seconds
=
max blinking
set unit is blinking
Adjustable from 0.0 km/h ... 5.0 km/h
file: n:\article\cos14310m5-v1_06hpc-en\20120504_cos14310m5-v1.06hpc-en_manual_h-p-cosmos_running_machine.docx
email@h-p-cosmos.com
§
indicating "donE"
$
and indicates: total distance covered in km
indicates km
$
and show: operation hours
reports: h
$
and report: operation hours
shows: h
!
reports "OP05" reports "typE"
indicates device type, e.g. "1.4"
$
indicates: „MCU 5"
reports default type, e.g. 1.3
shows: rtc for Real Time Clock
reports flashing: date / time, year, month, date, hours,
indicates: OFF or ON
indicates: stop time in sec.
indicates: sec for seconds
indicates: start speed in km/h
created 04.05.2012 printed 04.05.2012
operation
reports version, e.g. "1.01.1"
page: 65 of 191