Refilling Oil Tank - h/p/cosmos 150/50 mercury Operating And Service Manual

Valve cock position [1] vertically: the distributor [2] is adjusted for
lubrication [3] over the entire width of the running deck [4].
The valve cock position only influences the distribution of the amount of
oil to the various oil outlets (tubes). The total oil supply amount of the oil
pump always remains constant, independent of the valve cock position.
The control lamp "empty oil-tank" on the external control unit indicates
that the oil tank is nearly empty. Refill the oil-tank when the control lamp
illuminates. At standard settings the word "OIL" will flash after 1000 km
of operation. If this occurs, check the oil level in the oil tank and refill
preterm if necessary.
Because the device does not have a sensor, the oilmessage will not
extinguish automatically. After checking the oil level, the message has to
be reset with "OP01".
8.4.5

Refilling oil tank

Unplug the device and wait for one minute.
N
The oil tank is located in the external control unit of the device below at the left. (For devices constructed
N
before 2002 and without external control unit, the oil-tank is located at the rear of the machine close to the
drive engine.)
Open the lid of the tank and refill the oil-tank with approximately 0.5 litres of the provided original oil, which
N
can be ordered at h/p/cosmos. For devices constructed before 2002 and without an external control unit, add
approximately 1 to 1.5 litres)
Close the lid of the oil-tank, plug in the power plug and switch the device on.
N
Check control lamp on the external control unit. If it is no longer illuminated, the oil-tank has been sufficiently
N
refilled.
If necessary, reset the oil message with „OP 01".
N
Special oil for sliding plate with automatic lubrication/0.25l bottle [cos14007]
Special oil for sliding plate with automatic lubrication/0.50l bottle [cos13438]
8.4.6 Resetting of oil message
An external UserTerminal or the PC-software h/p/cosmos para control
UserTerminal.
Initiation: running belt is not moving. One of the mode LEDs
Step Activity
[01] Select of the mode for "user
options" (OPxx)
© 2012 h/p/cosmos sports & medical gmbh
wheelchair
Keys
a d b
press 3 keys
simultaneously for
at least 3 seconds
file: n:\article\cos14310m5-v1_06hpc-en\20120504_cos14310m5-v1.06hpc-en_manual_h-p-cosmos_running_machine.docx
email@h-p-cosmos.com
maintenance and safety inspections
is required for devices without
®
is flashing: manual, profile, cardio, test
Response/Display
=
indicates: OP01 flashing (for option no. 01)
! "
and indicate: E.rE SEt (for error reset)
created 04.05.2012 printed 04.05.2012 page: 105 of 191