h/p/cosmos 150/50 mercury Operating And Service Manual page 142

11.5 lectromagnetic compatibility (EMC) and immunity: Guidance and manufacturer's declaration
E
Guidance and manufacturer's declaration - electromagnetic emissions (for all equipment and systems)
The running machine is intended for use in the electromagnetic environment specified below. The customer or the user of the running machine should
assure that it is used in such an environment.
Emissions test
RF emissions CISPR11
RF emissions CISPR11
Harmonic emissions IEC 61000-3-2
Voltage fluctuations/ flicker emissions
IEC 61000-3-3
Guidance and manufacturer's declaration - electromagnetic immunity (for all equipment and systems)
The running machine is intended for use in the electromagnetic environment specified below. The customer or the user of the running machine should
assure that it is used in such an environment.
Immunity test
Electrostatic discharge (ESD)
IEC 61000-4-2
Electrical fast transient/burst
IEC 61000-4-4
Surge
IEC 61000-4-5
Voltage dips,
short interruptions and
voltage variations on
power supply input lines
IEC 61000-4-11
Power frequency (50/60
magnetic field
IEC 61000-4-8
NOTE U is the A.C. mains voltage prior to application of the test level.
T
EMC certification bodies: Mitsubishi Electric Europe / EMC-Laboratroy, Mündelheimer Weg 35, DE 40472 Düsseldorf
EMV Testhaus GmbH, Gustav - Hertz - Strasse 35, DE 94315 Straubing / Germany, J. Schmitz GmbH, DE 83022 Rosenheim / Germany
Strong electromagnetic fields, transmitters and interferences which are above the normal tolerance, can interfere with measuring fuctions and displays of the
running machines and can lead to other malfunctions.
Please pay special attention also to the other EMC related chapters of this manual:
Chapters: Safety, installation, operation, POLAR heart rate monitor, troubleshooting.
© 2012 h/p/cosmos sports & medical gmbh
Compliance
Group 1 Class B
Group 1 Class B
Class A
Complies
IEC 60601 test level
±6 kV contact
±8 kV air
±2 kV for power supply lines
±1 kV for input/output lines
±1 kV differential mode
±2 kV common mode
<5 % U
T
(>95 % dip in U )
T
for 0.5 cycle
40 % U
T
(60 % dip in U )
T
for 5 cycles
70 % U
T
(30 % dip in U )
T
for 25 cycles
<5 % U
T
(>95 % dip in U )
T
for 5 sec
Hz)
3 A/m
file: n:\article\cos14310m5-v1_06hpc-en\20120504_cos14310m5-v1.06hpc-en_manual_h-p-cosmos_running_machine.docx
email@h-p-cosmos.com
Electromagnetic environment — guidance
The running machine uses RF energy only for its internal function. Therefore, its RF
emissions are low and are not very likely to cause any interference in nearby
electronic equipment.
The running machine is suitable for use in all establishments including domestic
and those directly connected to the public low-voltage power supply network that
supplies buildings used for domestic purposes.
Compliance level
±6 kV contact
±8 kV air
±2 kV for power supply lines
±1 kV for input/output lines
±1 kV differential mode
±2 kV common mode
<5 % U
T
(>95 % dip in U )
T
for 0.5 cycle
40 % U
T
(60 % dip in U )
T
for 5 cycles
70 % U
T
(30 % dip in U )
T
for 25 cycles
<5 % U
T
(>95 % dip in U )
T
for 5 sec
Not applicable
created 04.05.2012 printed 04.05.2012
technical data
Electromagnetic environment - guidance
Floors should be wood, concrete or ceramic tile. If
floors are covered with synthetic material, the
relative humidity should be at least 30 %.
Mains power quality should be that of a typical
commercial or hospital environment.
Mains power quality should be that of a typical
commercial or hospital environment.
Mains power quality should be that of a typical
commercial or hospital environment. If the user of
the running machine requires continued operation
during power mains interruptions,
recommended that the running machine be
powered from an uninterruptible power supply or
a battery. Caution! Running machines require
high capacity UPS because of high capacity
motor drive.
Power frequency magnetic fields should be at
levels characteristic of a typical location in a
typical commercial or hospital environment.
page: 142 of 191
it is