h/p/cosmos 150/50 mercury Operating And Service Manual page 43

the running machine cancels after 2 minutes). If the heart rate signal fails during the operation in the cardio mode,
the running machine will continue running in the actual set speed and angle of inclination. In this case, beeper alert
signal will be activated every 30 seconds. The running machine will run down speed to 2 km/h and the mode will
be terminated after 1 minute (at MCU5 firmware-versions < V1.03.1 or MCU4 firmware-versions < V4.04.2, the
running machine chancels after 2 minutes).
Examples:
a) Set max. speed 4.0 km/h if you want the subject only to walk and to control the load by means of elevation.
b) Set max. speed 20.0 km/h if you want the subject to control the load by means of speed only without elevation.
The running machine adjusts speed and elevation according to the following matrix.
Chart for heart rate-controlled work load at the heart rate lower level
Heart rate difference actual > < set value
0 ... 5
5.1 ... 15
15.1 ... 30
30.1 ... 50
> 50
Chart for heart rate controlled work load at the heart rate upper level
Heart rate difference actual > < set value
0 ... 5
5.1 ... 15
15.1 ... 30
30.1 ... 50
> 50
The following table show the operating steps to run the the treadmill via firmware or software h/p/cosmos para control
Operation of cardio mode
Initiation: Running-Belt is not moving. One of the modes LED
Step no. Activity
[01] Select cardio mode
[02] Start cardio mode
[03] Change max. speed
for cardio mode
© 2012 h/p/cosmos sports & medical gmbh
Keys
a d
or
c
a d
or
file: n:\article\cos14310m5-v1_06hpc-en\20120504_cos14310m5-v1.06hpc-en_manual_h-p-cosmos_running_machine.docx
email@h-p-cosmos.com
Speed (km/h) Elevation (%)
0.2
0.4
0.6
0.8
1.0
Speed (km/h Elevation (%)
0.3
0.8
1.0
1.5
2.0
is flashing: (manual, profile, cardio, test)
Response / Display
Alteration of the mode (manual, profile, cardio, test)
until cardio is flashing
cardio is illuminated,
=
indicates 6.0 is (for max. speed during cardio mode).
This default value can be changed in the optional settings.
% is illuminated, energy is illuminated
=
indicates flashing: 2.0 ... max. speed of the running
machine (for max. allowed speed during cardio mode)
Examples:
a) Set max. speed 4.0 if you want the subject only to walk and
to control the load by means of elevation.
b) Set max. Speed 20.0 if you want the subject to control the
load by means of speed only without elevation.
created 04.05.2012 printed 04.05.2012
operation
Time (s)
0.1 25
0.2 25
0.4 25
0.8 20
1.0 20
Time (s)
0.3 12
0.8 12
1.0 10
1.2 8
1.6 7
speed max. is illuminated
page: 43 of 191
®